For the safe use of AIRBLOW: Before using AIRBLOW for the first time, read the instructions carefully. These instructions will help you understand the function of the product for the correct application.
Recommended use:
• Use AIRBLOW once a week. Further use is recommended when reduction in turbine spray is seen.
• After each airflow use, the use of AIRBLOW is recommended to ensure clear water flow.
• For quick-connectors and Luft Motor we recommend using AIRBLOW once a month Purpose of use: Connecting component for air transfer between the supply pipes of the dental seat and the flow mechanism of the hand piece and the airflow.
Always ensure correct operating conditions and proper operation of air flow. Use air produced by dental compressors, which is filtered, cold and without oil. * In case you do not have the desired results (i.e., air circulation at the water outlet of the cutter-air-rotor or airflow) you can use the compressed air at the same time with the cleaning pin at the water outlet. If we have no outcome you should contact the technical support of your cutting tool.

Do not switch the connector during operation
α Insert the quick release AIRBLOW into the pipe of the turbine.
β Tighten the nut tube turbine clockwise by hand, to ensure tightness.
γ Unscrew the nut tube turbine clockwise by hand.
• Carefully remove the quick release AIRBLOW from the pipe turbine. This assembly performs a connection of the drive mechanism with air, the cooling water supply and return air (only RM). Τightness link check
• Check the correct application of the flange (visually) in quick connector AIRBLOW
• If problems occur during operation (such as vibration, abnormal noise or leakage) you should immediately turn off the quick coupler AIRBLOW and contact an authorized service center.
• Comply with standards and specifications for disinfecting, cleaning and sterilization.
• If the unit is very dirty, clean it first with disinfectant wipes. Rinse and rub the appliance with tap water.
• Remove any residual fluids (with absorbent cloth, drying it with compressed air)
The AIRBLOW is manufactured from specially trained staff. The product has undergone a series of related controls to achieve proper operation. Noted that the claims arising from the guarantee are only valid if the instructions in this manual have been applied. The manufacturer is responsible for defects in material or manufacturing problems that occur within 24 months from the date of purchase. We accept no responsibility for damage caused due to incorrect use or for repairs by personnel not authorized! Any claims under the warranty should be addressed to the supplier of the equipment always on presentation of proof of purchase. The provision of services under the Guarantee shall not extend the warranty period nor any other warranty period.